This is great! I never understood how people learn how to make solid PCBs, I've made a few things but I think I must be missing some decoupling capacitors or resistors or whatever, because my microcontrollers aren't very stable. How do you all just know what stuff to put on the PCB? Do you read the datasheet for the component and add whatever is there?
Checking the datasheet is essential, they usually show the “must-have” parts around a chip. Beyond that, good habits are adding decoupling caps close to the pins, keeping ground solid, and following the reference layout. I also learned a lot just by listening to experienced designers explain their choices, like here: https://www.youtube.com/watch?v=aVUqaB0IMh4
If you're pulling the datasheet from the vendor website, you can also skim the list of documentation and see if there are any application notes available for the part.
For more "complicated" parts (e.g. lots of signals, high frequency, high power, etc.), integrating the part into a board design isn't necessarily straightforward. Rather than putting a ton of detail in the datasheet, the vendor will sometimes have an entirely separate document with design guidelines for the part.
basically every part will provide a minimal schematic in the datasheet or have a reference design you can copy from
some stuff may be somewhat glossed over, like usage of ground planes or which traces you're supposed to keep short, but when those are important they'll usually be mentioned, or even spelled out in a application note
Yeah, you have to read the data sheets. Beyond that, use decoupling caps for all power pins, as close to the chip as you can, and make one side of the PCB a ground plane. These 2 things should solve most of your issues.
